How do I set up WAN (Internet) Ethernet port
Ethernet port aggregation between two devices allows your devices to treat multiple Ethernet links as if they were a single link. Combining two network
Contact UsUnable to configure IP addresses on the aggregation port of a Layer 3 switch
Home / Unable to configure IP addresses on the aggregation port of a Layer 3 switch
To configure port aggregation, run aggregator-group id mode {lacp-negotiation |static }. The following list details the basic configuration parameters that should be consistent on all the ports: STP configurations, including STP enable or disable, STP priority, and STP cost. For a Layer 3 interface, if you want to configure a static IPv4 address, select IPv4 and refer to Configure Layer 3 Interfaces for configuring a static IPv4 address. LACP (Link Aggregation Control Protocol): LACP is an industry-standard protocol (802. 3ad) that dynamically manages link aggregation, provides automatic failover, and helps prevent misconfigurations by ensuring both ends of the link agree on the aggregation settings. Despite bundling multiple physical ports, the upper limit of transmission speed remains unchanged, as packets are still transmitted through a single.
