Configure to enable port 80 on Huawei fiber optic switch

Home / Configure to enable port 80 on Huawei fiber optic switch

To ​ enable a port ​ on a ​ Huawei switch, start by accessing the device's command-line interface (CLI) via a console cable or SSH. Use the system-view command to enter configuration mode, then navigate to the target port using interface GigabitEthernet 0/0/1 (replace with your. Commands provided in this section and all the parameters in the commands are supported by all switch models by default, unless otherwise specified. For example: Replace USERNAME with the new username, set the password, define service-type (telnet, ssh, etc.

Configure to enable port 80 on Huawei fiber optic switch PDF preview
Click to view
Configure to enable port 80 on Huawei fiber optic switch
PDF document
Downloaded 235 times

Network Access Through Internet-side Port 80, 8080, or 443 Fails

To resolve this problem, change the mapped Internet-side port to a port except ports 8080 and 443. For example, change it to port 1001. This document describes the concepts and configuration procedures

Contact Us

How to Enable Ports in Huawei Switch? Could Open Ports Unlock

This guide dives into the step-by-step process of port configuration on Huawei switches, while addressing the often-overlooked question: Does opening ports inadvertently create backdoors

Contact Us

Configuring Fibre Channel Interfaces

Cisco Nexus 5000 Series switches provide up to eight physical Fibre Channel uplinks. The Fibre Channel interfaces are supported on optional expansion modules. The Fibre Channel plus Ethernet

Contact Us

Network Access Through Internet-side Port 80, 8080, or 443 Fails

When devices on another network access the intranet, intranet port 80 is mapped to Internet-side port 80, causing an access failure. To resolve this problem, change the mapped Internet-side port to a

Contact Us

How to configure a optical fiber router modem to allow port forwarding

I have searched the internet fully and I found almost the same situation like this one - How to configure cable modem router to allow port forwarding to other connected router? But this

Contact Us

Configuring Fibre Channel Interfaces

Virtual Fibre Channel Interfaces Fibre Channel over Ethernet (FCoE) encapsulation allows a physical Ethernet cable to simultaneously carry Fibre Channel and Ethernet traffic. In Cisco Nexus 5000

Contact Us

Fiber To Wan | How to convert STC Huawei Gpon Fiber Router Lan Port

Title:- Fiber To Wan | How to convert STC Huawei Gpon Fiber Router Lan Port into Wan Port |fiber to wan portTopics Covered in this Video (Try to Ignore this)...

Contact Us

Access port config (Huawei)

How to set access port config on Huawei switch? An access port belongs to and carries the traffic of only one VLAN within 2-layer switch. Traffic is both

Contact Us

How to Enable Ports in Huawei Switch? Could Open Ports Unlock

Configuring ports on a Huawei switch is a fundamental yet critical task for network administrators. Whether you''re setting up a new network segment or troubleshooting connectivity

Contact Us

People also like:

Get In Touch

Connect With Us

📧

Email

[email protected]

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain