PROFIBUS bus connector
The bus lines are connected using an insulation displacement system (Fast Connect). The insulation displacement terminals are designed to withstand 10 terminating cycles.
Contact UsHow to install wire ends on a bus connector
Home / How to install wire ends on a bus connector
In the event of a fault, contact your Siemens representative responsible for spare parts/repairs: Screw terminal block on connector board for bus cable connection. Bring the bus terminal system into a safe, powered down state before starting installation, disassembly or wiring of the bus terminals! Terminals for standard wiring ELxxxx/KLxxxx and for pluggable wiring ESxxxx/KSxxxx Fig. Profibus or Pro cess Fi eld Bus is a standard within field bus communications in the automation industry. The two wire Profibus cable makes different network topologies possible, like the star, the tree and the line or a. In addition, they contain extensive specifications directed at PROFIBUS device developers. I could also just run a separate pair of wires to each of the 10 points, all converging back to one point (but this makes a "star" instead of a "bus" which may screw things up). In no event shall ABB be liable for direct, indirect, special, incidental or consequential damages of any nature or kind arising from the use of this document, nor shall ABB be liable for incidental or consequential damages arising from use of any software or hard-ware described in this document.
