Fiber optic pressure sensor based on a single-mode fiber F–P cavity

In this paper, we propose and experimentally demonstrate a pressure sensor based on birefringent single-mode fiber F–P cavity using optical heterodyne. The proof of concept device

Contact Us

A new type of structure of optical fiber pressure sensor based on

Optical fiber pressure sensor shows great performance with low cost. In this study, a new type of structure of optical fiber pressure sensor (OFPS) based on polarization modulation is

Contact Us

Low-pressure fiber-optic sensor by polyester Fabry-Perot cavity and its

This manuscript presents the development of a low-pressure extrinsic Fabry-Perot fiber optic sensor based on a thin polyester film, using a phase signal analysis. The proposed

Contact Us

Wiley Online Library | Scientific research articles, journals, books

Hier sollte eine Beschreibung angezeigt werden, diese Seite lässt dies jedoch nicht zu.

Contact Us

Fiber fusion splicing error analysis of all-fiber optic current sensor

Measurement accuracy is essential for the all-fiber optic current sensor. Angle errors of axis alignment in the fusion processing affect the measurement accuracy with different modulation and

Contact Us

High-Speed and Error-Suppressed Fiber-Optic F–P System for

Abstract: Spectral interrogation has been an effective method for fiber-optic Fabry–Perot (F–P) sensors, but it still suffers from low sampling rate, poor dynamic response, and potential jump errors. In this

Contact Us

The Experimental Validation of Designed Fiber Optic Pressure Sensors

This paper focused on the experimental validation of diaphragm-based Fabry-Perot fiber optic pressure sensors (D-FP-FOPS) with ethylene propylene diene terpolymers (EPDM) diaphragm as designed

Contact Us

Ways to Reduce the Errors of a Fiber-Optic Low-Pressure Sensor

The problem of improving the metrological characteristics of an attenuator-reflective low-pressure fiber-optic sensor located in narrow cavities with uneven surfaces, in particular, in life

Contact Us

Investigation of the errors of attenuator-type fiber-optic pressure sensors

The errors of attenuator-type fiber-optic pressure sensors are investigated. The sources of errors of these sensors are analyzed and methods of reducing them by construction-technological

Contact Us

Investigation of the errors of attenuator-type fiber-optic pressure sensors

The errors of attenuator-type fiber-optic pressure sensors are investigated. The sources of errors of these sensors are analyzed and methods of reducing them by...

Contact Us

Optical fiber pressure sensor using extrinsic Fabry-Perot

This paper discuss the theoretical analysis and experimental results of pressure measurement using optical fiber sensor with cladding modification and

Contact Us

Review of high sensitivity fibre-optic pressure sensors for low

Abstract Fibre Bragg grating (FBG) pressure sensors show a great potential in replacing conventional electrical pressure sensors due to their numerous advantages. However, increasing

Contact Us

Assessment of Fiber Optic Pressure Sensors

This report presents the results of a six-month Phase I study to establish the state-of-the-art in fiber optic pressure sensing and describes the design and principle of operation of various fiber optic pressure

Contact Us

Well-scale demonstration of distributed pressure sensing using fiber

In this study, we used data from optical fiber-based Distributed Acoustic Sensor (DAS) and Distributed Temperature Sensor (DTS) to estimate pressure along the fiber.

Contact Us

Analysis and elimination of bias error in a fiber-optic current sensor

Citations (13) References (11) Abstract Bias error, along with scale factor, is a key factor that affects the measurement accuracy of the fiber-optic current sensor.

Contact Us

Review of fiber-optic pressure sensors for biomedical and biomechanical

Fiber-optic sensing technology is about forty years old and presents substantial advantages compared to conventional elec- tric sensing systems. Conventional sensors applied in

Contact Us

Accurate measurement for high-pressure based on fiber optic Fabry

A technique for high-accuracy pressure measurement in the range of 11-109 MPa is demonstrated. It involves an encapsulated Fabry-Perot sensor and a spectral interrogation system. The full-scale

Contact Us

Pressure Sensor Based on the Fiber-Optic Extrinsic Fabry-Perot

Abstract: Pressure sensors based on fiber-optic extrinsic Fabry-Perot interferometer (EFPI) have been extensively applied in various industrial and biomedical fields. In this paper, some key improvements

Contact Us

High-Speed and Error-Suppressed Fiber-Optic F–P System for

In this article, we present a novel spectral interrogation system for the F–P sensor, with the advantages of error suppression and high speed.

Contact Us

Fiber Optic Pressure Sensor

In this paper, we demonstrated how much the optical power on the optical fiber is affected when applying a pressure on its core but also, we demonstrated the high sensitivity of the fiber optic based

Contact Us

Review of high sensitivity fibre-optic pressure sensors for low

This paper aims to explore the recent progress of fibre optic pressure sensing technologies that are suitable for low hydrostatic pressure detection. It will first outline the history of FBG and bare

Contact Us

People also like:

Get In Touch

Connect With Us

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain