TP LINK COMPATIBLE GPON ONU STICK WITH MAC AND

TP Switch Aggregation Settings

In this guide, I will be demonstrating how to set up a LAG (Link Aggregation Group) using LACP. The two TP-Link switches used as examples are the TP-Link T1500G-10MPS Power over Ethernet (PoE) smart switch (affiliate link) and the TP-Link T2600G-28TS switch (affiliate link). 3ad, is used to combine multiple physical links dynamically as a logical link, and thus this logical link will have higher bandwidth and. The TP-Link TL-SG108 switch supports link aggregation, allowing users to enhance network performance.

GPON optical module type class n2a

The 10G-XGPON-SFP-N2a module operates as a bidirectional transceiver utilizing 1577nm wavelength for downstream transmission and 1270nm for upstream reception, enabling full-duplex communication over a single strand of single-mode fiber. Our XG-PON OLT Class N2a SFP+ transceiver enables high-capacity 10G FTTH deployments for next-generation broadband networks. Supporting 20km over single-mode fiber with 1577/1270nm wavelengths, this module delivers 33. These modules are typically installed in Optical Line Terminals (OLTs) at the service provider's central office and Optical Network Units (ONUs) or Optical Network.

Principle and Function of GPON Optical Splitter

Its main function is to separate and convert optical signals to achieve data transmission and reception. According to the Broadband Forum, PLC splitters are essential for achieving scalable and cost-effective GPON and XGS-PON deployment in access networks. This document describes the Gigabit Passive Optical Network (GPON) technology and how it functions.

How much does a GPON optical module need

Class B+ modules offer a standard optical budget (28 dB), suitable for most GPON deployments. A GPON optical module is a transceiver used in GPON networks to convert electrical signals into optical signals and vice versa. It works best over long distances where large amounts of information need to be sent without active electrical components between.

GPON and optical port modules

Service port interface function - Provides translation between service interfaces and the TC frame interface of the PON section. In the scenario that the ONU/OLT operates with a single PON interface (max 2 for protection purposes), the cross-connect function is omitted. ONU Management and Control Interface (OMCI) messages are used to discover ONT/ONUs for management and control.

Get In Touch

Connect With Us

📧

Email

[email protected]

📱

Spain Office (HQ)

+34 936 214 587

🇪🇺

EU Technical Center

+49 89 452 38 217

📍

Headquarters (Spain)

Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain