Bit Error Rate (BER) is a measure of telecommunication signal integrity based on the quantity or percentage of transmitted bits that are received incorrectly.
Read More
For this, numerous techniques are proposed to beat the PAPR problem like i) Selective mapping (SLM) ii) Partial transmit sequence (PTS), iii) Clipping, iv) Clipping and filtering. Current technological objectives for OFDM focus primarily on optimizing bit error rate (BER) performance, particularly in high-data-rate applications where transmission reliability directly impacts user experience. However, one amongst the foremost drawbacks of the OFDM system is that the high-peak-to-average power ratio (PAPR) that leads the system to provide in-band distortion and out-of-band radiation and reduces its efficiency. OFDM can be implemented easily, it is spectrally efficient and can provide high data rates with sufficient robustness to channel imperfections. Abstract-In this paper we present an analytical approach to evaluate the bit error rate (BER) of OFDM systems subject to carrier frequency offset (CFO) and channel estimation error in Rayleigh flat fading as well as in time and frequency selective fading channels.
Read More
As an example, assume this transmitted bit sequence: 1 1 0 0 0 1 0 1 1 and the following received bit sequence: 0 1 0 1 0 1 0 0 1, The numbe.
Read More
If two or more optical modules have the same SN, bogus optical modules are used. Based on typical issues encountered with optical modules in daily switch applications, this document summarizes basic troubleshooting steps for resolving common faults: 1. This document describes how to check the switch interface or port status and how to locate an interface physically down fault and restore the interface to the up state. Verification events including pluggable authentication, verification transceiver optical power, the signal transmission quality.
Read More
A passive optical network (PON) is a fiber-optic telecommunications network that uses only unpowered devices to carry signals, as opposed to electronic equipment. In practice, PONs are typically used for the last mile between Internet service providers (ISP) and their customers. A PON takes advantage of (WDM), using one wavelength for downstream traffic and another for upstream traffic on a (ITU-T, typically OS2).
Read More+34 936 214 587
+49 89 452 38 217
Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain