SPECTROMETER OPTICAL LIGHT AMP WAVELENGTH BRITANNICA

The longer the wavelength of optical fiber communication the lower the attenuation

This phenomenon occurs due to the varying interactions between the light and the fiber material at different wavelengths. For fiber optics with glass fibers, we use light in the infrared region which has wavelengths longer than visible light, typically around 850, 1300 and 1550 nm. The most important elements of optical communication are a transmission medium with extremely low optical attenuation and a highly stable, long-life light source that operates with a small current. Their wavelength adaptation relationship is the first step in optical fiber system design.

Relay optical cable test wavelength

That is, if the system is open at 1550 wavelength, the test wavelength is 1550nm. Because different wavelengths correspond to different light characteristics (including attenuation, microbending, etc. The fiber optic link attenuation is tested using an optical loss test set (OLTS) or a light source and power meter (LSPM) Figure 1). This type of testing is the most accurate testing available and is the most accurate characterization of the fiber optic system's apability.

Is the optical module not configured to transmit light independently

Sometimes the optical module is replaced by an electrical interface module that implements either an active or passive electrical connection to the outside world.

Optical module is faulty and cannot emit light

If the fault is caused by incorrect configuration or networking environment, change the configuration or networking environment. Customers in the use of optical modules will more or less encounter a variety of failure problems, such as optical module model selection is correct, the use of jumper is correct and some common problems, customers have the ability to judge and have a clear solution, but for some of the use of. Check compatibility between the optical module and switch Most switch brands have specific compatibility requirements. Whether there is obvious damage, component burned black, dehiscence, leakage, even tin or not.

Optical module emits excessive light

If the fault is caused by the configuration or environment, advise the customer to optimize the configuration or environment. Customers in the use of optical modules will more or less encounter a variety of failure problems, such as optical module model selection is correct, the use of jumper is correct and some common problems, customers have the ability to judge and have a clear solution, but for some of the use of. The article Digital Diagnostic Function (DDM) For Optical Modules describes that DDM function can be used for real-time monitoring and fault location of the module's working status, in which the optical module's transmitting optical power and receiving optical power are the key parameters for. Whether there is obvious damage, component burned black, dehiscence, leakage, even tin or not.

SPECTROMETER OPTICAL LIGHT AMP WAVELENGTH BRITANNICA

The longer the wavelength of optical fiber communication the lower the attenuation

Relay optical cable test wavelength

Is the optical module not configured to transmit light independently

Optical module is faulty and cannot emit light

Optical module emits excessive light

Get In Touch

Connect With Us

Email

Spain Office (HQ)

EU Technical Center

Headquarters (Spain)