Relay protection E0 and E1
The objective of relay protection is to quickly isolate a faulty section from both ends so that the rest of the system can function satisfactorily.
Read More
Indoor optical cable bare fiber protection
An optical cable wraps bare fibers in layers that absorb stress, block water, resist UV, and survive pulls. Compared with outdoor use fiber cable, indoor fiber optic cable experience less temperature and mechanical stress, but they have to be fire retardant, emit a low level of smoke in case of burning and also allow a small bend radius to make them be amendable to vertical installation and handle. Bare fiber refers to the fundamental glass strand of an optical fiber without any protective coatings, buffers, or jackets. In the European Union the indoor cable have to be classified according to the Construction Product Regulation (CPR).
Read More
Can fire protection power lines be run through cable trays
This cable can be installed in cable trays in Division 1 locations and can also provide fire protection. Cable tray systems must comply with article 318 with respect to ampacity, grounding, fill, spacing and segregation of cable types. Electrical lines can ignite themselves due to overheating or a short-circuit or they can be set alight by the external influence of fire or heat. Electrical cable tray wall penetration firestopping Scope: Firestopping for busway, cable trays, cables, and trunking passing through walls in enclosed electrical installations. Cable Trays have been permitted in the hazardous (classified) locations in the National Electrical Code for Class I (flammable vapor and gases) since the 1978 NEC and have been used extensively in chemical plants, refineries, and other types of facilities.
Read More
Relay Protection Current Tester
The CMC 356 is the universal six-phase testing solution for all generations and types of protection relays, where highest versatility, amplitude and power are required.
Read More
Why do relay protection systems need to be measured
Protective relay testing ensures that your system responds correctly to abnormal conditions. The testing and verification of relay protection devices can be divided into four groups: Type tests are needed to prove that a protection relay meets the claimed specification and follows all relevant standards. We provide guidance regarding test signals, propose a number of ways to measure and compare relay performance, discuss the issue of. But failure to operate as intended can result in extensive damage, extended power outages, and loss of life.
Read More