Where should the fiber optic cold splice be inserted
The bare fibers at both ends need to be snapped into the snap ring in the middle of the cold splicer, and the snap rings on both sides should be pushed tightly, and then tested, and the production is successful. The steps of optical fiber cold splicing are as follows: ① First install the cold connector, buckle the snap rings on both sides, and snap down the middle slot; ② Strip the fiber, strip about 3CM long, and wipe it with alcohol; ③ Put in the cutting knife and cut about 1. At the heart of any robust fiber optic network lies a crucial process: Preparing a fiber cable for termination of a connector or splice. Whether repairing a broken cable or extending a fiber run, fiber optic splicing ensures light signals travel. Strip one side, cleave it, insert it into the splice, then strip the other fiber.
Read More
