Fire protection cables and low-voltage cables share the same cable tray
Power-limited fire alarm circuits and Class 2 circuits can be within the same cable, cable tray, cable routing assembly, enclosure, or raceway provided the Class 2 circuit insulation is not less than that required for the power-limited fire alarm circuits. There are really two considerations insulation failure /damage- what sort if cable is the UTP (would the jacket of the lower rated cable hold off mains voltages ) if so then they could be as close as you like,otherwise it should be segragated by split duct or similar. Correct cabling practices are fundamental to the reliability of life safety, security, and electrical systems. Class 2 circuits typically include wiring for low-energy (100VA or less), low-voltage (under 30V) loads such as low-voltage lighting, thermostats, PLCs, security systems, and limited-energy voice, intercom, sound, and public address systems. Fire prevention and protection systems (FPPS) require cables that meet proper technical standards, especially related to fire-resistant cables (FR) and flame-retardant cables (FRT).
Read More
