ADD EDIT AND REMOVE MEMBERS OF GROUPS IN OUTLOOK

Add lightning protection to the power distribution box in the computer room

The power distribution box of the computer room should be equipped with SPD (anti-electromagnetic surge) protection devices to prevent the power supply of the computer room from being cut off due to electromagnetic pulses caused by lightning strikes. Our light-ning and surge voltage protection systems are per-fectly matched to one another and to the requirements in the different zones – from the air-termination device, which must arrest the full energy of a lightning strike, through to fine power protection, which eliminates the last voltage. one designed to protect the building structure and fabric and a second to protect sensitive equipment inside the building.

How to remove dust from a distribution box

Regularly clean the distribution board using a soft brush or vacuum cleaner to remove dust or debris. Perform circular vacuuming around the sides of the cabinet and the incoming cable entries at the bottom to prevent dust from falling inside. Our Air Cleaning Blowers present an innovative solution that not only effectively eliminates dust but also provides added benefits for a more efficient and productive environment.

Do not remove jumpers from fiber optic cables

When installing a fiber jumper, excessive force may exert pressure on it and the connectors on both ends, thus affecting its performance. Consult the cable specification sheet for the cable you are installing Do not bend the cable more sharply than the minimum recomme ded bend radius. Fiber doesn't wear out or degrade (to any reasonable extent in any reasonable timeframe, outside of poor outdoor splices or extreme environments) or oxidize, is digital not analog, so they either work or don't (the later being broken due to abuse or extreme environments).

How to remove the protective layer from pigtail fibers

The coating can readily be removed with conventional fiber stripping tools such as the Clauss CFS-1 or Fitel S-210 for fiber with a 125 μm cladding diameter or a Clauss No Nik stripper for cladding diameters larger than 125 m. Many outside plant cables are also filled with a gel to block the axial migration of water. This application note addresses general handling of fibers from NKT Photonics, including how to strip the protective coating, how to cleave the fibers and tips for coupling light to and from the fibers. 9mm outer jacket, tight buffered, which you can strip down to 250μm, and then one has to remove the colored layer on the last few cm to strip them down to 125μm bare glass fiber, to cleave and splice. Are they damaged? Are any of them cut? Even a small % of cut fibers will significantly reduce finished-product pull strength. For splicing, connectorization or other processing, these coatings must be removed.

What is the tool used to remove the sheath of optical cables called

Fiber Cable Slitters a simple-to-use and effective tool to remove the outer jacket of optic fiber cables. Also known as optical fiber cable strippers, they hold cable within a slot, squeeze their jaws to press through the coating, and slide the coating off the end of the cable. At Emtelle, we provide a wide range of associated products designed to complement and enhance your network infrastructure.

ADD EDIT AND REMOVE MEMBERS OF GROUPS IN OUTLOOK

Add lightning protection to the power distribution box in the computer room

How to remove dust from a distribution box

Do not remove jumpers from fiber optic cables

How to remove the protective layer from pigtail fibers

What is the tool used to remove the sheath of optical cables called

Get In Touch

Connect With Us

Email

Spain Office (HQ)

EU Technical Center

Headquarters (Spain)