Optical attenuators are commonly used in fiber-optic communications, either to test power level margins by temporarily adding a calibrated amount of signal loss, or installed permanently to properly match transmitter and receiver levels. The power reduction is done by such means as absorption, reflection, diffusion, scattering, deflection, diffraction, and dispersion, etc.
Read More
This part of IEC 60794 describes test procedures to evaluate the coefficient of dynamic friction of the sheathing material of a cable when pulled over or between other cables. How does this large, blue-colored wheel help us as a lubricant manufacturer? The reel test has proven to be a. For a given technique, cable construction, installation method (pulling, pushing, or blowing), and du t size, the relative values of the COF can give some indication as to the relative ease of. Several new methods of installing fiber optic cable in continuous conduit use high speed air flow to "push" the cable, rather than the traditional threaded line to pull it.
Read More
Demand Factor = Maximum demand of a system / Total connected load on the system. The management of energy demand requires the efficient utilization of energy resources, the maintenance of a reliable supply, and the management of energy resources in an overall efficient manner. It accounts for equipment not operating simultaneously at full load, applying diversity factors for realistic assessment. The diversity factors vary based on premises type (household, commercial, or hospitality). This factor must be applied to each individual load, with particular attention to electric motors, which are very rarely operated at full load.
Read More+34 936 214 587
+49 89 452 38 217
Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain