The Bridge of the Americas (Spanish: Puente de las Américas; originally known as the Thatcher Ferry Bridge) is a road bridge in Panama which spans the Pacific entrance to the Panama Canal. Designed by American civil engineering company Sverdrup & Parcel, it was completed in 1962 at a cost of US$20 million. Two other bridges cross the canal: the Atlantic Bridge at the Gatun locks and the C.
Read More
Construction of the Fourth Bridge over the Panama Canal has officially resumed at 100% capacity following a strike by construction workers. The strike, which began in late April 2025, temporarily halted several important infrastructure projects managed by Panama's Ministry of Public. 42 billion project was awarded to the Chinese consortium in 2018 by the government of Juan Carlos Varela and was scheduled to be completed in 2023. This was informed by the head of the Ministry of Public Works (MOP), José Luis Andrade, during a recent tour.
Read More
To avoid transverse bending at higher loads, a joint plate must be used for tray widths of 400 mm or more in the joint area of the cable trays that are to be connected. Developed by Interstates, this cable tray cutting guide acts as a guide for a metal cutting circular saw for cutting the side rail of a cable tray as well as a guide for drilling the connecting holes in the cable tray. A rung spacing of 6 to 9 inches (150 to 230 mm) is preferable when the cable tray cont d for instrumentation and control applications that require. The most common method of locating the hole positions is to use a splice plate as a template.
Read More
In general, vertical spacing for cable trays should be 30 cm (12 in), measured from the bottom of the upper tray to the top of the lower tray. This is a description of how to select, install, and support these metal or plastic frames, on which electrical wires are installed. Wire Mesh Cable Trays are mainly used for telecommunication and fiber optic cables. Any installed cable ladder, cable tray or channel support system can be considered structurally as a loaded beam (Figures 2); four basic beam configurations may be found in a typical installation: • Simply supported beam • Fixed beam • Continuous beam • Cantilever A single length of cable ladder.
Read More
This junction allows reliable and neat formation of a T-shaped branching of cable routes, ensuring stable and safe cable routing in different directions. Fitting for the construction of T-joints or crossovers of Metatray® insulating trays for the conduction of electrical and telecommunication cables.
Read More+34 936 214 587
+49 89 452 38 217
Calle de la Tecnología 47, 08840 Viladecans, Barcelona, Spain